by Dodger 359 Fri Apr 25, 2014 8:30 pmJust wanted to post some pictures from my passenger seat install. The seat I ordered from this following link :http://www.jeep4x4center.com/smittybilt-low-back-bucket-seat-black-sb-44801.html is wider than factory but fits. This van was ordered with no passenger seat and did not have any hardware for a seat at all.
The drivers seat is factory. The passenger seat is the jeep seat.
I used low profile uni-strut to fabricate the seat rails. I still need to spot weld the brackets to the fender.
I plated the bottom of the seat so that the rails could be mounted on the seat the same as the drivers side.
Thanks for looking.
The drivers seat is factory. The passenger seat is the jeep seat.
I used low profile uni-strut to fabricate the seat rails. I still need to spot weld the brackets to the fender.
I plated the bottom of the seat so that the rails could be mounted on the seat the same as the drivers side.
Thanks for looking.
Last edited by Dodger 359 on Sun Apr 27, 2014 7:23 pm; edited 1 time in total (Reason for editing : Added information)
